Samsung A33 5G SM-A336M/E/B ISP PINOUT (UFS)

Photo of author
Published on:
Follow

In this article, we’ll show you Samsung A33 5G SM-A336M/E/B UFS ISP Pinout that allows you to write DUMP file, Chip re-programming, or flash firmware or remove frp lock, bypass FRP, remove locks, and flash the stock firmware using any UFS repair tool.

What is UFS ISP Pinout?

ISP (In-System Programming) allows flash chip to be programmed without removing it from the PCB. It uses a specific pinout and protocol to communicate with computer.

A test point is a copper points on a PCB that allows you to boot the phone into the emergency download mode to perform flashing, unlocking or repairing the phone.

Read more: Samsung S22 Ultra SM-S908E ISP PINOUT

Samsung A33 5G SM-A336M/E/B UFS ISP PinOUT Diagram Image:

The Samsung A33 5G ISP and Test Point enables you to carefully boot into Flash Mode. So, follow the below methods to successfully boot to ISP Mode.

Also read: How to Enter Download or EDL Mode on Oppo Phone

Samsung A33 5G SM-A336M/E/B ISP PINOUT (UFS)

More: QPST Tool – Qualcomm QPST Flash Tool Download Latest All Version

UFS ISP Pin Labels You Need:

  • CLK
  • TXOP
  • TXON
  • RXOP
  • RXON
  • GND – Ground

Tip: You can use a microscope or a 10x magnifier to identify the points correctly.

Do read: Honor X5b Plus GFY-LX3 ISP PINOUT (EMMC)

Required Tools for ISP Pinout Method

Make sure your workstation includes:

  • UFI Box, Easy JTAG Plus, or Medusa Pro
  • 0.1mm – 0.3mm jumper wires
  • Fine-tip soldering iron
  • Soldering flux
  • Isopropyl Alcohol (IPA 99%)
  • Multimeter
  • Microscope or magnifier

Also read: Realme C55 RMX3710 Test Point

How to Connect ISP to UFS or EMMC Box

  • Open the back panel of the Samsung A33 5G.
  • Disassemble the phone.
  • Locate the eMMC chip area on the PCB.
  • Find & Solder to ISP Points
  • Use the above diagram to identify these pins: CLK, TXON, TXOP, GND, and RXON, RXOP.
  • Samsung A33 5G SM-A336M/E/B UFS ISP PinOUT to Hard Reset, FRP Bypass or Flash firmware.
  • Or, you can use the test points.
  • Connect to UFI or Easy JTAG,
  • In the UFI or Easy Jtag Software:
  • Click Identify UFS
  • Bypass FRP: Navigate to: User Partition – Special Task – Reset FRP
  • Fix Dead Boot: Select the firmware & click flash.
  • That’s it.

Also: Vivo Y17s V2310 ISP PINOUT (EMMC)

Share on:

I write about Android FRP Solutions, Android problems, GSM tutorials. If your device stuck at the Google Account Verification screen then here you can find all the possible ways to Bypass it. In my free time, I love to play games:

Recommended Reading…

Leave a Comment